推薦產品
產品介紹
CEDAR DID-4扭力螺絲刀
特點:LC液晶顯示；RS232C輸出口；扭力測試功能；數據記憶功能；操作簡單方便。
規格:
| 型號 | DSD-4 |
| 測試范圍 | 0.001-4N.m |
| 精度 | 0.5% |
| 測試方向 | 正反方向 |
| 測試判斷 | 可設置限值 |
| 電源 | 充電5小時可用12小時 |
| Specification | DID-4 | ||
| Measuring range | 0.020 - 4 N-m | ||
| 0.20～40 kgf-cm | |||
| 0.20～35 lbf-in | |||
| Accuracy | ± 0.5% （in case of reading 499 or less = last digit +/- 3 reading） | ||
| Display | The 4 figures digital display of LCD | ||
| The measurement direction | CW-CCW （right and left） | ||
| Measuring mode | P-P Peak | Holding Peak Load Value | |
| T-R Track | Showing Real time torque value （ Used for Zero-Adjustment ） | ||
| P-D Peak down | Holding Load Value at the moment to change from upward to downword | ||
| C Real-time output | Load torque value is outputted every about 1/ 160. | ||
| Decision function | Setting of torque value | Programmable High and Low setpoints with both audible beep and Green/Red LED indicator for uniform torque tightening or GO/NO GO testing | |
| The Maximum, the minimum, and the average value | Displays, memory and output the data number, the maximum, the minimum, and the average value of the measured value to 30 data. It can save by a maximum of 10 channels. | ||
| Data spec. | Data transfer | ASCII format （Baud rate : 19200） When outputting data,the cable（USB miniB） is needed. | |
| Data memory | 800 data / ten channels data | ||
| A setup of the number of counts | One to 99 count （count in a direction with a bundle） | ||
| Power supply | Ni-Cd chargeable battery 1.2V×4cells 600mAh | ||
| Auto power save | 10 minutes no use, automatically switch off. | ||
| Charging time | From empty - less than 5hours | ||
| Continunous working time | 12 hours | ||
| Bit /Socket part | HEX6.35 | ||
| Weight | about 400g | ||
在線交流
咨詢電話
